HP A5500 EI - Public-Key Peer Import Sshkey

216
Default level
2: System level
Parameters
keyname: Specifies the peer public key name, a case-sensitive string of 1 to 64 characters.
Description
Use the public-key peer command to specify a name for a peer public key and enter public key view.
Use the undo public-key peer command to remove a peer public key.
To manually configure a peer public key on the local host, obtain the public key (in hexadecimal) from
the peer beforehand and perform the following configurations:
1. Execute the public-key peer command, and then the public-key-code begin command to enter
public key code view.
2. Type the peer public key.
3. Execute the public-key-code end command to save the public key and return to public key view.
4. Execute the peer-public-key end command to return to system view.
Related commands: public-key-code begin, public-key-code end, peer-public-key end, and display
public-key peer.
Examples
# Specify the name for the peer public key as key1 and enter public key view.
<Sysname> system-view
[Sysname] public-key peer key1
[Sysname-pkey-public-key]
public-key peer import sshkey
Syntax
public-key peer keyname import sshkey filename
undo public-key peer keyname
View
System view
Default level
2: System level
Parameters
keyname: Specifies a public key name, a case-sensitive string of 1 to 64 characters.
filename: Specifies the name of the file that saves a peer host public key. For more information about file
name, see the Fundamentals Configuration Guide.
Description
Use the public-key peer import sshkey command to import a peer host public key from the public key file.
Use the undo public-key peer command to remove the specified peer host public key.