EasyManua.ls Logo

HP A5500 EI - Dot1 X Multicast-Trigger; Dot1 X Port-Control

HP A5500 EI
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
107
Related commands: display dot1x.
Examples
# Set the maximum number of concurrent 802.1X users on port GigabitEthernet 1/0/1 to 32.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface gigabitethernet 1/0/1
Or
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x max-user 32
# Configure GigabitEthernet 1/0/2 through GigabitEthernet 1/0/5 each to support a maximum of 32
concurrent 802.1X users.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface gigabitethernet 1/0/2 to gigabitethernet 1/0/5
dot1x multicast-trigger
Syntax
dot1x multicast-trigger
undo dot1x multicast-trigger
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use the dot1x multicast-trigger command to enable the 802.1X multicast trigger function. The device acts
as the initiator and multicasts EAP-Request/Identify packets periodically to the clients.
Use the undo dot1x multicast-trigger command to disable the function.
By default, the multicast trigger function is enabled.
Related commands: display dot1x.
Examples
# Enable the multicast trigger function on interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x multicast-trigger
dot1x port-control
Syntax
In system view:

Table of Contents

Related product manuals