HP A5500 EI User Manual

80
Parameters
ip-address: IP address of the primary HWTACACS authentication server, a valid unicast address in dotted
decimal notation. The default is 0.0.0.0.
port-number: Port number of the primary HWTACACS authentication server. It ranges from 1 to 65535
and defaults to 49.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN that the primary HWTACACS authentication
server belongs to, where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the server is
on the public network, do not specify this keyword and argument combination.
Description
Use the primary authentication command to specify the primary HWTACACS authentication server.
Use the undo primary authentication command to remove the configuration.
By default, no primary HWTACACS authentication server is specified.
The IP addresses of the primary and secondary authentication servers cannot be the same. Otherwise, the
configuration fails.
The HWTACACS service port configured on the device and that of the HWTACACS server must be
consistent.
If the server to be specified resides on an MPLS VPN, you also need to specify that VPN by using the
vpn-instance vpn-instance-name keyword and argument combination to ensure normal communication
with the server. The VPN specified here takes precedence over the VPN specified for the RADIUS scheme.
If you configure the command repeatedly, only the last configuration takes effect.
You can remove an authentication server only when it is not used by any active TCP connection to send
authentication packets.
Related commands: display hwtacacs, hwtacacs scheme, and vpn-instance (HWTACACS scheme view).
Examples
# Specify the IP address and port number of the primary authentication server for HWTACACS scheme
hwt1 as 10.163.155.13 and 49.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authentication 10.163.155.13 49
primary authorization
Syntax
primary authorization ip-address [ port-number | vpn-instance vpn-instance-name ] *
undo primary authorization
View
HWTACACS scheme view
Default level
2: System level
Parameters
ip-address: IP address of the primary HWTACACS authorization server, a valid unicast address in dotted
decimal notation. The default is 0.0.0.0.

HP A5500 EI Specifications

General

Brand	HP
Model	A5500 EI
Category	Network Router
Language	English