HP A5500 EI - Dot1 X Authentication-Method

100
Examples
# Enable 802.1X for ports GigabitEthernet 1/0/1, and GigabitEthernet 1/0/5 to GigabitEthernet 1/0/7.
<Sysname> system-view
[Sysname] dot1x interface gigabitethernet 1/0/1 gigabitethernet 1/0/5 to gigabitethernet
1/0/7
Or
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/5
[Sysname-GigabitEthernet1/0/5] dot1x
[Sysname-GigabitEthernet1/0/5] quit
[Sysname] interface gigabitethernet 1/0/6
[Sysname-GigabitEthernet1/0/6] dot1x
[Sysname-GigabitEthernet1/0/6] quit
[Sysname] interface gigabitethernet 1/0/7
[Sysname-GigabitEthernet1/0/7] dot1x
# Enable 802.1X globally.
<Sysname> system-view
[Sysname] dot1x
dot1x authentication-method
Syntax
dot1x authentication-method { chap | eap | pap }
undo dot1x authentication-method
View
System view
Default level
2: System level
Parameters
chap: Sets the access device to perform Extensible Authentication Protocol (EAP) termination and use the
Challenge Handshake Authentication Protocol (CHAP) to communicate with the RADIUS server.
eap: Sets the access device to relay EAP packets.
pap: Sets the access device to perform EAP termination and use the Password Authentication Protocol
(PAP) to communicate with the RADIUS server.
Description
Use the dot1x authentication-method command to specify an EAP message handling method.
Use the undo dot1x authentication-method command to restore the default.
By default, the network access device performs EAP termination and uses CHAP to communicate with the
RADIUS server.