36
Description
Use the service-type command to specify the service types that a user can use.
Use the undo service-type command to delete one or all service types configured for a user.
By default, a user is authorized with no service.
Examples
# Authorize user user1 to use the Telnet service.
<Sysname> system-view
[Sysname] local-user user1
[Sysname-luser-user1] service-type telnet
state(local user view)
Syntax
state { active | block }
undo state
View
ISP domain view, local user view
Default level
2: System level
Parameters
active: Places the local user in the active state to allow the local user to request network services.
block: Places the local user in the blocked state to prevent the local user from requesting network services.
Description
Use the state command to set the status of a local user.
Use the undo state command to restore the default.
By default, a local user is in the active state.
By default, a local user is in the active state.
By blocking a user, you disable the user from requesting network services. No other users are affected.
Related commands: local-user.
Examples
# Place the current user user1 to the blocked state.
<Sysname> system-view
[Sysname] local-user user1
[Sysname-luser-user1] state block
user-group
Syntax
user-group group-name
undo user-group group-name
To Next Page
Loading...
Need help?
General
