152
portal nas-ip (available only on the A5500 EI)
Syntax
portal nas-ip ip-address
undo portal nas-ip
View
Interface view
Default level
2: System level
Parameters
ip-address: Specifies the source IP address to be specified for portal packets. This IP address must be a
local IP address, and cannot be 0.0.0.0, 255.255.255.255, a class D address, a class E address, or a
loopback address.
Description
Use the portal nas-ip command to configure the source IP address for the interface to use for portal
packets to be sent.
Use the undo portal nas-ip command to restore the default.
By default, no source IP address is specified, and the IP address of the user access interface is used as the
source IP address of the portal packets.
Examples
# Configure the source IP address for portal packets to be sent on VLAN-interface 5 as 2.2.2.2.
<Sysname> system-view
[Sysname] interface vlan-interface 5
[Sysname-Vlan-interface5] portal nas-ip 2.2.2.2
portal nas-port-type (available only on the A5500 EI)
Syntax
portal nas-port-type { ethernet | wireless }
undo portal nas-port-type
View
Interface view
Default level
2: System level
Parameters
ethernet: Specifies the access port type as Ethernet, which corresponds to code 15.
wireless: Specifies the access port type as IEEE 802.11 standard wireless interface, which corresponds to
code 19. This keyword is usually specified on an interface for wireless portal users, ensuring that the NAS-
Port-Type value delivered by the access device to the RADIUS server is wireless.
To Next Page
Loading...
Need help?
General
