67
stop-accounting-buffer enable (RADIUS scheme view)
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Default level
2: System level
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the device to buffer stop-accounting requests
getting no responses.
Use the undo stop-accounting-buffer enable command to disable the device from buffering stop-
accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no responses.
Stop-accounting requests affect the charge to users. A NAS must make its best effort to send every stop-
accounting request to the RADIUS accounting servers. For each stop-accounting request getting no
response in the specified period of time, the NAS buffers and resends the packet until it receives a
response or the number of transmission attempts reaches the configured limit. In the latter case, the NAS
discards the packet. However, if you have removed the accounting server, stop-accounting messages are
not buffered.
Related commands: reset stop-accounting-buffer, radius scheme, and display stop-accounting-buffer.
Examples
# In RADIUS scheme radius1, enable the device to buffer the stop-accounting requests getting no
responses.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] stop-accounting-buffer enable
timer quiet (RADIUS scheme view)
Syntax
timer quiet minutes
undo timer quiet
View
RADIUS scheme view
Default level
2: System level
To Next Page
Loading...
Need help?
General
