EasyManua.ls Logo

HP A5500 EI - ARP Filtering Configuration Commands

HP A5500 EI
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
319
Parameters
mac-address&<1-10>: Specifies a MAC address list. The mac-address argument indicates a protected
MAC address in the format H-H-H. &<1-10> indicates the number of protected MAC addresses that you
can configure.
Description
Use the arp anti-attack source-mac exclude-mac command to configure protected MAC addresses that
are excluded from ARP packet detection.
Use the undo arp anti-attack source-mac exclude-mac command to remove the configured protected
MAC addresses.
By default, no protected MAC address is configured.
If no MAC address is specified in the undo arp anti-attack source-mac exclude-mac command, all the
configured protected MAC addresses are removed.
Examples
# Configure a protected MAC address.
<Sysname> system-view
[Sysname] arp anti-attack source-mac exclude-mac 2-2-2
arp anti-attack source-mac threshold
Syntax
arp anti-attack source-mac threshold threshold-value
undo arp anti-attack source-mac threshold
View
System view
Default level
2: System level
Parameters
threshold-value: Specifies the threshold for source MAC address based ARP attack detection, in the range
10 to 100.
Description
Use the arp anti-attack source-mac threshold command to configure the threshold for source MAC
address based ARP attack detection. If the number of ARP packets sent from a MAC address within five
seconds exceeds this threshold, the switch considers this an attack.
Use the undo arp anti-attack source-mac threshold command to restore the default.
By default, the threshold for source MAC address based ARP attack detection is 50.
Examples
# Configure the threshold for source MAC address based ARP attack detection as 30.
<Sysname> system-view
[Sysname] arp anti-attack source-mac threshold 30

Table of Contents

Related product manuals