2
Default level
2: System level
Parameters
max-user-number: Maximum number of users, in the range 1 to 2147483646.
Description
Use the access-limit enable command to enable the limit on the number of users in an ISP domain and set
the allowed maximum number. After the number of users reaches the maximum number allowed, no more
users will be accepted.
Use the undo access-limit enable command to restore the default.
By default, there is no limit to the number of users in an ISP domain.
System resources are limited, and user connections may compete for network resources when there are
many users. Setting a proper limit to the number of users helps provide reliable system performance.
Examples
# Set a limit of 500 user connections for ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] access-limit enable 500
accounting command
Syntax
accounting command hwtacacs-scheme hwtacacs-scheme-name
undo accounting command
View
ISP domain view
Default level
2: System level
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Specifies an HWTACACS scheme by its name, which is a
string of 1 to 32 characters.
Description
Use the accounting command command to specify the command line accounting method.
Use the undo accounting command command to restore the default.
By default, the default accounting method for the ISP domain is used for command line accounting.
The specified HWTACACS scheme must have been configured.
Command line accounting can use only a HWTACACS scheme.
Related commands: accounting default and hwtacacs scheme.
Examples
# Configure ISP domain test to use HWTACACS scheme hwtac for command line accounting.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
