110
# Configure ports GigabitEthernet 1/0/2 through GigabitEthernet 1/0/5 to implement port-based
access control.
<Sysname> system-view
[Sysname] dot1x port-method portbased interface gigabitethernet 1/0/2 to gigabitethernet
1/0/5
dot1x quiet-period
Syntax
dot1x quiet-period
undo dot1x quiet-period
View
System view
Default level
2: System level
Parameters
None
Description
Use the dot1x quiet-period command to enable the quiet timer. When a client fails 802.1X
authentication, the device must wait a period of time before it can process authentication requests from
the client.
Use the undo dot1x quiet-period command to disable the timer.
By default, the quite timer is disabled.
Related commands: display dot1x and dot1x timer.
Examples
# Enable the quiet timer.
<Sysname> system-view
[Sysname] dot1x quiet-period
dot1x re-authenticate
Syntax
dot1x re-authenticate
undo dot1x re-authenticate
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
To Next Page
Loading...
Need help?
General
