EasyManua.ls Logo

HP A5500 EI - Mac-Authentication Max-User; Mac-Authentication Timer

HP A5500 EI
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
123
To use the MAC authentication guest VLAN function on a port, you must enable MAC-based VLAN on the
port, in addition to enabling MAC authentication both globally and on the port.
To delete a VLAN that has been set as a MAC authentication guest VLAN, remove the guest VLAN
configuration first.
Related commands: mac-authentication; mac-vlan enable (Layer 2
LAN Switching Command
Reference).
Examples
# Configure VLAN 5 as the MAC authentication guest VLAN on port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mac-authentication guest-vlan 5
mac-authentication max-user
Syntax
mac-authentication max-user user-number
undo mac-authentication max-user
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
user-number: Specifies the maximum number of concurrent MAC authentication users allowed on the port.
The value ranges from 1 to 256.
Parameters
Use the mac-authentication max-user command to set the maximum number of concurrent MAC
authentication users on a port.
Use the undo mac-authentication max-user command to restore the default.
The default maximum number of concurrent MAC authentication users allowed on a port is 256.
Examples
# Configure port GigabitEthernet 1/0/1 to allow up to 32 concurrent MAC authentication users.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mac-authentication max-user 32
mac-authentication timer
Syntax
mac-authentication timer { offline-detect offline-detect-value | quiet quiet-value | server-timeout server-
timeout-value }
undo mac-authentication timer { offline-detect | quiet | server-timeout }

Table of Contents

Related product manuals