250
View
Any view
Default level
1: Monitor level
Parameters
tunnel-id integer: Specifies an IPsec tunnel by its ID, which is in the range 1 to 2000000000.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use the display ipsec statistics command to display IPsec packet statistics.
If you do not specify any argument, the command displays statistics on all IPsec packets.
Related commands: reset ipsec statistics.
Examples
# Display statistics on all IPsec packets.
<Sysname> display ipsec statistics
the security packet statistics:
input/output security packets: 47/62
input/output security bytes: 3948/5208
input/output dropped security packets: 0/45
dropped security packet detail:
not enough memory: 0
can't find SA: 45
queue is full: 0
authentication has failed: 0
wrong length: 0
replay packet: 0
packet too long: 0
wrong SA: 0
# Display IPsec packet statistics for Tunnel 3.
<Sysname> display ipsec statistics tunnel-id 3
------------------------------------------------
Connection ID : 3
------------------------------------------------
the security packet statistics:
input/output security packets: 5124/8231
input/output security bytes: 52348/64356
input/output dropped security packets: 0/0
dropped security packet detail:
To Next Page
Loading...
Need help?
General
