HP Aruba JL253A - Page 117

LLCP Port Configuration Detail
Port : 4
AdminStatus [Tx_Rx] : Tx_Rx
NotificationsEnabled [False] : False
Med Topology Trap Enabled [False] : False
TLVS Advertised:
* port_descr
* system_name
* system_descr
* system_cap
* capabilities
* network_policy
* location_id
* poe
* macphy_config
* poeplus_config
IpAddress Advertised:
Local power information on page 117 shows an Example: of the local device power information using the show
lldp info local-device <port-list> command.
Local power information
switch(config)# show lldp info local-device A1
LLCP Local Port Information Detail
Port : A1
PortType : local
PortId : 1
PortDesc : A1
Pvid : 1
Poe Plus Information Detail
Poe Device Type : Type2 PSE
Power Source : Primary
Power Priority : low
PD Requested Power Value : 20 Watts
PSE Actual Power Value : 20 Watts
Remote power information on page 117 shows the remote device power information using the show lldp
info remote-device <port-list> command.
Remote power information
switch(config)# show lldp info remote-device A3
LLCP Remote Device Information Detail
Local Port : A3
ChassisType : mac-address
ChassisId : 00 16 35 ff 2d 40
PortType : local
PortId : 23
SysName : Switch
Chapter 4 Power Over Ethernet (PoE/PoE+) Operation 117