HP Aruba JL253A - Page 152

Syntax:
trunk-load-balance L3-based | [L4-based >]
This option enables load balancing based on port layer information. The configuration is executed in global
configuration context and applies to the entire switch.
Default: L3-based load balancing
L2-based:
Load balance based on Layer 2 information.
L3-based:
Load balance based on Layer 3 information if present, or Layer 2 information.
L4-based:
Load balance on Layer 4 port information if present, or Layer 3 if present, or Layer 2.
Enabling L4-based trunk load balancing
switch(config)# trunk-load-balance L4 based
Output when L4-based trunk load balancing is enabled
Switch(config)# show trunk
Load Balancing Method: L4-based
Port | Name Type | Group Type
---- + ----------------------------- --------- + ------ -------
41 100/1000T Trk1 Trunk
42 100/1000T Trk1 Trunk
Note in
Running config file when L4-based trunk load balancing is enabled on page 152 that in if L4 trunk
load balancing is enabled, a line appears in the running-config file. If it is not enabled, nothing appears as this is
the default and the default values are not displayed.
Running config file when L4-based trunk load balancing is enabled
switch(config)# show running-config
Running configuration
; J9091A Configuration Editor; Created on release #XX.15.02.0001x
hostname "Switch"
module 1 type J8702A
module 5 type J9051A
module 7 type J8705A
module 10 type J8708A
module 12 type J8702A
trunk-load-balance L4-based
vlan 1
name "DEFAULT_VLAN"
untagged A1-A24, G1-G24, J1-J4, L1-L24
ip address dhcp-bootp
tagged EUP
no untagged EDP
exit
snmp-server community "public" unrestricted
152 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08