HP Aruba JL253A - Page 264

hex
Specify hexadecimal string as option code value.
ip
Specify one or more IP addresses as option code value.
ip-addr-str
Specify IP address.
ascii-str
Enter an ASCII string.
hex-str
Specify Hexadecimal string.
Configure the raw DHCP server options.
NOTE: Following DHCP options are not supported:
1,3,6,12,15,44,46,50,52,54,55,57,58,59,61,66,67,82.
You can use the following available CLIs for respective DHCP option codes:
DHCP
Option
code
CLI Syntax
1
[no] network <ip-addr/mask-lenght>
3
[no] default-router <IP-ADDR-STR> [IP-ADDR2 ... IP-ADDR8]
6
[no] dns-server <IP-ADDR> [IP-ADDR2 ... IP-ADDR8]
15
[no] domain-name <name>
44
[no] netbios-name-server <IP-ADDR-STR> [IP-ADDR2 ... IP-ADDR8]
43
[no] option 43 {ascii <ascii-string>|hex <hex-string>|ip <IP-
ADDR-STR>[IP-ADDR2 … IP-ADDR8]}
46
[no] netbios-node-type <broadcast | hybrid | mixed | peer-to-
peer>
60
[no] option 60 {ascii <ascii-string>|hex <hex-string>|ip <IP-
ADDR-STR>[IP-ADDR2 … IP-ADDR8]}
66
[no] tftp-server server-name < ASCII-STR>
67
[no] bootfile-name<filename>
138
[no] option 138 {ascii <ascii-string>|hex <hex-string>|ip <IP-
ADDR-STR>[IP-ADDR2 … IP-ADDR8]}
150 [no] tftp-server server-ip <ip-address> or [no] option 150 <IP-
ADDR-STR> [IP-ADDR2 ... IP-ADDR8]
NOTE: DHCP server raw Option 43 is supported and it is used for AirWave ZTP.
DHCP server raw Option 60 is supported from 16.06.
DHCP server raw Option 138 is supported and it is used for IPsec tunnel configuration in DHCP
client.
264 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08