HP Aruba JL253A - Page 630

Command context
manager
Parameters
<reserved-vid>
Specifies the reserved VLAN ID.
Examples
switch(config)# show vlan <reserved-vid>
Status and Counters - VLAN Information - VLAN <reserved-vid>
VLAN ID : <reserved-vid>
Name : TUNNELED_NODE_SERVER_RESERVED
Status : Port-based
Voice : No
Jumbo : No
Private VLAN : none
Associated Primary VID : none
Associated Secondary VIDs : none
Port Information Mode Unknown VLAN Status
---------------- -------- ------------ -----------------------
NOTE: The user will not be able to delete the reserved VLAN. Reserved VLAN will be automatically
removed once the reserved-vlan parameter is removed from tunneled-node configuration.
show tunneled-node-server
Syntax
show tunneled-node-server [information | statistics <controller> | state <controller>]
Description
Shows the tunneled-node-server information, statistics, or state.
NOTE: Information for SAC and SSAC Switch Anchor Controller (SAC), Standby Anchor Controller
(SSAC) and User Anchor Controller (UAC) is available in the ArubaOS-Switch Controller Guide at
https://support.arubanetworks.com/.
Command context
manager or operator
Parameters
information
Specifies tunneled-node-server information, node-list, and the bucket map information.
statistics <controller>
Specifies the data plane statistics with respect to a controller for each port.
state <controller>
Specifies the data plane state with respect to a controller.
630 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08