HPE Apollo 2000

Operations 41
o
1U left rear I/O blank
o 2U rear I/O blank
2. Install the node into the chassis ("Installing a node into the chassis" on page 60).
3. Connect all peripheral cable to the node.
4. Power up the node ("Power up the nodes" on page 32).
Remove the air baffle
1. Power down the node (on page 32).
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis (on page 32).
4. Place the node on a flat, level surface.
5. If installed in a 2U node, remove the FlexibleLOM 2U node riser cage assembly ("FlexibleLOM 2U
node riser cage assembly" on page 52).