HPE Apollo 2000 User Manual

Operations 52
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless
all PCI riser cages or rear I/O blanks are i
nstalled, and do not operate the node unless all PCI
slots have either an expansion slot cover or an expansion board installed.
FlexibleLOM 2U node riser cage assembly
To remove the component:
1. Power down the node (on page 32).
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis (on page 32).
4. Place the node on a flat, level surface.
5. Remove the FlexibleLOM 2U node riser cage assembly.
Three-slot riser cage assemblies
NOTE: Three-
slot riser cage assemblies feature different riser boards. For more information
on the riser board slot specifications, see "PCIe riser board slot definitions (on page 26)."
To remove the component:
1. Power down the node (on page 32).
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis (on page 32).
4. Place the node on a flat, level surface.

HPE Apollo 2000 Specifications

General

Form Factor	2U
Memory Type	DDR4
Max Processors	2
Memory Slots	16 DIMM slots per server tray
Storage Options	SAS, SATA
Networking	FlexibleLOM
Network	1/10/25/40/100 GbE options
Power Supply	Redundant Power Supplies
Power Supply Options	1600W
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Storage	Up to 24 drives