HPE Apollo 2000

Operations 34
Remove the RCM module
To remove the component:
1. Power down all nodes ("Power down the node" on page 32).
2. Access the product rear panel.
3. Disconnect all cables from the RCM module.
4. Remove the RCM module.
Remove the power supply
To remove the component:
1. Power down all nodes ("Power down the node" on page 32).
2. Access the product rear panel.
3. If installed, remove the RCM module (on page 34).
4. Release the power cord from the strain relief strap.
5. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the chassis.