Setup 57
CAUTION:
Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
Rack warnings
WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:
• The leveling jacks are extended to the floor.
• The full weight of the rack rests on the leveling jacks.
• The stabilizing feet are attached to the rack if it is a single-rack installation.
• The racks are coupled together in multiple-rack installations.
• Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
WARNING: To reduce the risk of personal injury or equipment damage when unloading a
rack:
•
At least two people are needed to safely unload the rack from the pallet. An empty 42U rack
can weigh as much as 115 kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might
become unstable when being moved on its casters.
• Never stand in front of the rack when it is rolling down the ramp from the pallet. Always
handle the rack from both sides.
WARNING: To reduce the risk of personal injury or damage to the equipment, adequately
stabilize the rack before extending a component outside the rack. Extend only one component
at a time. A rack may become unstable if more than one component is extended.
WARNING:
When installing a server in a telco rack, be sure that the rack frame is adequately
secured at the top and bottom to the building structure.
Unpacking the system
Unpack the following hardware and prepare for installation:
• HPE Apollo 2000 System
• Power cord
• Rack mounting hardware kit
• Rack rail strain relief strap
• Printed setup documentation
In addition to the supplied items, you might need:
• T-25 Torx screwdriver (to secure the chassis in the rack)
• T-10/T-15 Torx screwdriver (to install hardware options)
• Flathead screwdriver (to remove the knockout on the dedicated iLO connector opening)
• Hardware options
Installation overview
To set up and install the HPE Apollo 2000 System:
1. Set up and install the rack. For more information, see the documentation that ships with the rack.
To Next Page
Loading...
Need help?
General
