HPE Apollo 2000 User Manual

Hardware options installation 73
7.
If using the RCM module iLO ports to connect the chassis to a network, connect all cables to the
RCM module and the network. Multiple chassis can be connected to the same network.
NOTE: Arrow indicates connection to the network.
8. If an HPE APM is installed, connect the cables to the RCM module, the APM, and the network
("Connecting the optional HPE APM module" on page 61).
9. Reconnect all power:
a. Connect each power cord to the power source.
b. Connect the power cord to the chassis.
10. Power up the nodes (on page 32).
RCM 2.0 to 1.0 adapter cable
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
1. Power down all nodes ("Power down the node" on page 32).
2. Disconnect each power cord from the power source.
3. Install the RCM module ("RCM module" on page 70).

HPE Apollo 2000 Specifications

General

Form Factor	2U
Memory Type	DDR4
Max Processors	2
Memory Slots	16 DIMM slots per server tray
Storage Options	SAS, SATA
Networking	FlexibleLOM
Network	1/10/25/40/100 GbE options
Power Supply	Redundant Power Supplies
Power Supply Options	1600W
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Storage	Up to 24 drives