HPE FlexNetwork 5510 HI Series

102
Retry Limit : 10 Retry Interval : 2 sec
Reoptimization : Disabled Reoptimization Freq : -
Backup Type : None Backup LSP ID : -
Auto Bandwidth : Disabled Auto Bandwidth Freq : -
Min Bandwidth : - Max Bandwidth : -
Collected Bandwidth : -
# Execute the display mpls lsp verbose command on Switch A to display detailed information
about the bidirectional MPLS TE tunnel.
[SwitchA] display mpls lsp verbose
Destination : 4.4.4.9
FEC : 1.1.1.9/1/30478
Protocol : RSVP
LSR Type : Ingress
Service : -
NHLFE ID : 1027
State : Active
Out-Label : 1149
Nexthop : 10.1.1.2
Out-Interface: Vlan1
Destination : 4.4.4.9
FEC : 1.1.1.9/1/30478
Protocol : RSVP
LSR Type : Egress
Service : -
In-Label : 1151
State : Active
Nexthop : 127.0.0.1
Out-Interface: -
Destination : 10.1.1.2
FEC : 10.1.1.2
Protocol : Local
LSR Type : Ingress
Service : -
NHLFE ID : 1026
State : Active
Nexthop : 10.1.1.2
Out-Interface: Vlan1
# Execute the display interface tunnel command on Switch D. The output shows that the tunnel
interface is up.
[SwitchD] display interface tunnel
Tunnel4 current state: UP
Line protocol current state: UP
Description: Tunnel8 Interface
The Maximum Transmit Unit is 64000
Internet Address is 8.1.1.1/24 Primary
Tunnel source unknown, destination 1.1.1.9