363
no default PW ID is configured, you must
provide a PW ID in the
peer
command.
You must specify the
no-split-horizon
keyword to disable split horizon when you
configure an NPE to establish a U-PW with
a UPE.
Configuring an LDP PW
Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information
about MPLS LDP configuration, see "Configuring LDP."
To configure an LDP PW:
1. Enter system view.
system-view
N/A
2. Enter VSI view.
vsi
vsi-name
N/A
3. Specify LDP signaling
for PWs, and enter
VSI LDP signaling
view.
pwsignaling
ldp
By default, no PW signaling protocol is
specified.
4. Configure an LDP PW,
and enter
PW view.
peer
ip-address [
pw-id
pw-id ]
[
no-split-horizon
|
pw-class
class-name |
tunnel-policy
tunnel-policy-name ] *
By default, no LDP PW is configured.
If you have configured a default PW ID
for the VSI with the
default-pw-id
command, you can use the default PW
ID without providing a PW ID in the
peer
command. If no default PW ID is
configured, you must provide a PW ID
in the
peer
command.
You must specify the
no-split-horizon
keyword to disable split horizon when
you configure an NPE to establish a
U-PW with a UPE.
Configuring a BGP PW
To configure a BGP PW, perform the following configurations on PEs:
• Configure BGP to advertise VPLS label block information.
• Create a BGP PW.
Configuring BGP to advertise VPLS label block information
1. Enter system view.
N/A
2. Enable BGP and enter BGP
view.
bgp
as-number
By default, BGP is not enabled.
3. Configure the remote PE as
a BGP peer.
peer
{ group-name | ip-address
[ mask-length ] }
as-number
as-number
By default, no BGP peer is
configured.
4. Crea
address-family l2vpn
To Next Page
Loading...
Need help?
General