HPE FlexNetwork 5510 HI Series Mpls Configuration Guide

364
Step
Command
Remarks
address family and enter
BGP L2VPN address family
view.
address family is created.
5.
Enable BGP to exchange
L2VPN information with the
specified peer or peer group.
peer
{ group-name | ip-address
[ mask-length ] }
enable
By default, BGP cannot
exchange L2VPN information
with any peer or peer group.
6.
Enable BGP to exchange
label block infor
mation with
the specified peer or peer
group.
peer
{ group-name | ip-address
[ mask-length ] }
signaling
By default, BGP can exchange
label block information with a
BGP L2VPN peer or peer group.
7. (Optional.)
Permit the local
AS number to appear in
routes from the specified
peer or peer group and
specify the appearance
times.
peer
{ group-name | ip-address
[ mask-length ] }
allow-as-loop
[ number ]
By default, the local AS number
is not allowed in routes from a
peer or peer group.
8. (Optional.) En
able route
target-
based filtering of
incoming BGP L2VPN
information.
policy vpn-target
By default, route target-based
filtering of incoming BGP L2VPN
information is enabled.
9. (Optional.)
Configure the
router as a route reflector
and specify a peer or peer
group as its client.
peer
{ group-name | ip-address
[ mask-length ] }
reflect-client
By default, no route reflector or
client is configured.
10. (Optional.)
Enable L2VPN
information reflection
between clients.
reflect between-clients
By default, L2VPN information
reflection is enabled between
clients.
11. (Optional.)
Configure the
cluster ID of the route
reflector.
reflector cluster-id
{ cluster-id |
ip-address }
By default, a route reflector uses
its own router ID as the cluster
ID.
12. (Optional.) Co
nfigure the
filtering of reflected L2VPN
information.
rr-filter
extended-community-number
By default, the route reflector
does not filter reflected L2VPN
information.
13.
(Optional.) Return to user
view.
return
N/A
14. (Optional.) Soft-reset L2VPN
BGP sessions.
refresh bgp
{ ip-address
[ mask-length ] |
all
|
external
|
group
group-name |
internal
}
{
export
|
import
}
l2vpn
N/A
15. (Optional.) Reset L2VPN
BGP sessions.
reset bgp
{ as-number | ip-address
[ mask-length ] |
all
|
external
|
group
group-name |
internal
}
l2vpn
N/A
For more information about the peer as-number, peer enable, peer allow-as-loop, peer
reflect-client, reflect between-clients, reflector cluster-id, refresh bgp, and reset bgp
commands, see Layer 3—IP Routing Command Reference.
Creating a BGP PW
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VSI view.
vsi
vsi-name N/A

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English