HPE FlexNetwork 5510 HI Series

141
To configure RSVP authentication in interface view:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable RSVP authentication
on the interface and
configure the authentication
key.
rsvp authentication key
{
cipher
|
plain
} auth-key
By default, RSVP authentication
is disabled.
Do not enable both RSVP
authentication and FRR on the
same interface.
4. Enable challenge-response
handshake on the interface.
rsvp authentication challenge
By default, the
challenge-
response handshake
function is disabled.
5. Configure the idle timeout for
RSVP security associations
on the interface.
rsvp authentication lifetime
life-time
By default, the idle timeout is 1800
seconds (30 minutes).
6.
Specify the maximum
number of out-of-sequence
RSVP authentication
messages that can be
received on the interface.
rsvp authentication
window-size
number
By default, only one RSVP
authenticated message can be
received out of sequence.
To configure RSVP authentication in RSVP view:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter RSVP view.
rsvp
N/A
3. Enable RSVP authentication
globally and configure the
authentication key.
authentication key
{
cipher
|
plain
} auth-key
By default, RSVP authentication
is disabled.
4. Enable challenge-response
handshake globally.
authentication challenge
By default, the
challenge-
response handshake
function is disabled.
5.
Configure the global idle
timeout for RSVP security
associations.
authentication lifetime
life-time
By default, the idle timeout is 1800
seconds (30 minutes).
6.
Specify the global RSVP
authentication window
size—the maximum number
of RSVP authenticated
messages that can be
received out of sequence.
authentication window-size
number
By default, only one RSVP
authenticated message can be
received out of sequence.
Specifying a DSCP value for outgoing RSVP
packets
The DSCP value of an IP packet specifies the priority level of the packet and affects the transmission
priority of the packet.
To specify a DSCP value for outgoing RSVP packets: