HPE FlexNetwork 5510 HI Series

268
Step
Command
Remarks
limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from storing
too many routes.
5. Apply an import routing
policy.
import route-policy
route-policy
By default, all routes matching the
import target attribute are
accepted.
Make sure the routing policy
already exists. Otherwise, the
device does not filter received
routes.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
6. Apply an export routing
policy.
export route-policy
route-policy
By default, routes to be advertised
are not filtered.
Make sure the routing policy
alread
y exists. Otherwise, the
device does not filter routes to be
advertised.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
7. Apply a tunnel policy to the
VPN instance.
tnl-policy
tunnel-policy-name
By default, only one tunn
el is
selected (no load balancing) in
this order: LSP tunnel, GRE
tunnel, and CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."
Configuring routing between a PE and a CE
You can configure IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, EBGP, or IBGP between a PE and
a CE.
Configuring IPv6 static routing between a PE and a CE
Step
Command
Remarks
1. Enter system view.
system-view
N/A