323
group-name ] [
slot
slot-number ] [
verbose
]
Display L2VPN PW information.
display
l2vpn
pw
[
xconnect-group
group-name ] [
ldp
|
static
]
[
verbose
]
Display PW class information.
display l2vpn pw-class
[ class-name ]
Display Ethernet service instance
information.
display l2vpn service-instance
[
interface
interface-type
interface-number [
instance-id ] ] [
]
Display cross-
information.
display
l2vpn
xconnect-group
[
name
group-name
]
[
]
Display L2VPN label block information.
display l2vpn bgp
[
peer
ip-address |
local
] [
xconnect-group
group-name ] [
verbose
]
Display BGP
information.
display bgp group l2vpn
[
group-name
group-name ]
Display L2VPN label block information
maintained by BGP.
display bgp l2vpn signaling
[
peer
ip-address {
advertised
|
received
} [
statistics
] |
route-distinguisher
route-distinguisher [
site-id
site-id [
label-offset
label-offset
[
advertise-info
] ] ] |
statistics
]
Display BGP L2VPN peer information.
display bgp peer l2vpn
[ ip-address mask-length | { ip-address |
group-name
group-name }
log-info
| [ [ ip-address ]
verbose
]
[
slot-number ] ]
Display BGP L2VPN update group
information.
display bgp update-group l2vpn
[
ip-address ]
Reset BGP sessions for L2VPN.
reset bgp
{ as-number | ip-address [ mask-length ] |
all
|
external
|
group
group-name |
internal
}
l2vpn
For more information about the display bgp group l2vpn, display bgp peer l2vpn, display bgp
update-group l2vpn, and reset bgp commands, see Layer 3—IP Routing Command Reference.
MPLS L2VPN configuration examples
Configuring a static PW
Network requirements
Create a static PW between PE 1 and PE 2 over the backbone so that CE 1 and CE 2 can
communicate within VLAN 10.
Figure 87 Network diagram
MPLS or IP backbone
CE 1 CE 2
PE 1 PE 2P
Vlan-int20
Vlan-int20
Vlan-int30
Vlan-int30
GE1/0/1 GE1/0/1
GE1/0/1
GE1/0/1
Loop0 Loop0 Loop0
Site 1 Site 2
To Next Page
Loading...
Need help?
General