HPE FlexNetwork 5510 HI Series Mpls Configuration Guide

80
Task
Command
Display sub-TLV information for IS-IS TE.
display isis mpls te configured-sub-tlvs
[ process-id ]
Display network information in an IS-IS TEDB.
display isis mpls te network
[ [
level-1
|
level-2
] |
local
|
lsp-id
lsp-id ]* [ process-id ]
Display IS-IS tunnel interface information.
display isis mpls te tunnel
[
level-1
|
level-2
]
[ process-id
]
Display DS-TE information.
display mpls te ds-te
Display bandwidth information on MPLS
TE-enabled interfaces.
display mpls te link-management
bandwidth-allocation
[
interface
interface-type
interface-number ]
Display MPLS TEDB information.
display mpls te tedb
{ {
isis
{
level-1
|
level-2
} |
ospf
area
area-id } |
link
ip-address |
network
|
node
[
local
|
mpls-lsr-id ] |
summary
}
Display information about MPLS
TE tunnel
interfaces.
display mpls te tunnel-interface
[
tunnel
number ]
Display link and node information in an OSPF
TEDB.
display ospf
[ process-id ] [
area
area-id ]
mpls te
advertisement
[
originate-router
advertising-router-id |
self-originate
]
Display network information in an OSPF TEDB.
display ospf
[ process-id ] [
area
area-id ]
mpls te
network
[
originate-router
advertising-router-id |
self-originate
]
Display OSPF tunnel interface information.
display ospf
[ process-id ] [
area
area-id ]
mpls te
tunnel
Reset the automatic bandwidth adjustment
function.
reset mpls te auto-bandwidth-adjustment timers
MPLS TE configuration examples
Establishing an MPLS TE tunnel over a static CRLSP
Network requirements
Switch A, Switch B, and Switch C run IS-IS.
Establish an MPLS TE tunnel over a static CRLSP from Switch A to Switch C.
The MPLS TE tunnel requires a bandwidth of 2000 kbps. The maximum bandwidth of the link that the
tunnel traverses is 10000 kbps. The maximum reservable bandwidth of the link is 5000 kbps.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English