446
2. Configure an IPv6
static route for an IPv6
VPN instance.
ipv6 route-static
vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [
public
] |
vpn-instance
d-vpn-instance-name
nexthop-address } [
permanent
] [
preference
preference-value ] [
tag
tag-value ] [
description
description-text ]
By
default, no IPv6
static route is
configured.
3. (Optional.) Configure
the default preference
for IPv6 static routes.
ipv6 route-static default-preference
default-preference-value
The default value is 60.
Configuring RIPng between an MCE and a PE
1. Enter system view.
system-view
N/A
2. Create a RIPng process for
enter RIPng view.
ripng
[ process-id ]
vpn-instance
vpn-instance-name
N/A
3. Redistribute VPN routes.
import-route
protocol
[
process-id
] [
allow-ibgp
]
[
allow-direct
|
cost
cost
|
route-policy
route-policy-name ]
*
By default, no routes are
redistributed into RIPng.
4. (Optional.)
Configure the
default cost value for
redistributed routes.
default cost
value
The default value is 0.
5. Return to system view.
N/A
6. Enter interface view.
interface
interface-type
interface-number
N/A
7. Enable the RIPng process on
the interface.
ripng
process-id
enable
By default, RIPng is disabled on
an interface.
Configuring OSPFv3 between an MCE and a PE
1. Enter system view.
system-view
N/A
2. Create an OSPFv3 process
and enter OSPFv3 view.
ospfv3
[ process-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Set the router ID.
router-id
router-id
N/A
4. Disable routing loop
detection.
vpn-instance-capability simple
By default, routing loop detection
is enabled.
On an
disable routing loop detection for
an OSPFv3 VRF process.
Otherwise, the MCE does not
receive OSPFv3 routes from the
PE.
5. (Optional.)
OSPFv3 domain ID.
domain-id
{ domain-id
[
secondary
] |
null
}
The default domain ID is 0.
To Next Page
Loading...
Need help?
General