HPE FlexNetwork MSR Series

379
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++
+++++
++++++++
# Export the host public key to file pubkey.
[RouterA] public-key local export rsa ssh2 pubkey
[RouterA] quit
# Transmit the public key file to the server through FTP or TFTP . (Details not shown.)
2. Configure the SFTP server:
# Generate the RSA key pairs.
<RouterB> system-view
[RouterB] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++
+++++
++++++++
# Generate a DSA key pair.
[RouterB] public-key local create dsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server function.
[RouterB] ssh server enable
# Enable the SFTP server function.
[RouterB] sftp server enable
# Configure an IP address for interface Ethernet 1/1. The client uses this address as the
destination address of the SSH connection.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ip address 192.168.0.1 255.255.255.0
[RouterB-Ethernet1/1] quit
# Set the authentication mode of the user interfaces to AAA.
[RouterB] user-interface vty 0 4