HPE FlexNetwork MSR Series Comware 5 Security Configuration Guide

38
Task Remarks
Specifying the shared keys for secure HWTACACS communication
Required.
Specifying a VPN for the HWTACACS scheme
Optional.
Setting the username format and traffic statistics units
Optional.
Specifying the source IP address for outgoing HWTACACS packets
Optional.
Setting HWTACACS timers
Optional.
Displaying and maintaining HWTACACS
Optional.
Creating an HWTACACS scheme
The HWTACACS protocol is configured on a per scheme basis. Before you perform other
HWTACACS configurations, create an HWTACACS scheme and enter HWTACACS scheme view.
You can configure up to 16 HWTACACS schemes.
To create an HWTACACS scheme and enter HWTACACS scheme view:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an HWTACACS scheme and
enter HWTACACS scheme view.
hwtacacs scheme
hwtacacs-scheme-name
Not defined by default.
You can delete an HWTACACS scheme only when it is not referenced.
Specifying the HWTACACS authentication servers
You can specify one primary authentication server and one secondary authentication server for an
HWTACACS scheme. When the primary server is not available, the secondary server is used. In a
scenario where redundancy is not required, specify only the primary server.
An HWTACACS server can function as the primary authentication server of one scheme and as the
secondary authentication server of another scheme at the same time. You cannot specify the same
IP address as both the primary and the secondary authentication servers in a scheme.
To specify HWTACACS authentication servers for an HWTACACS scheme:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter HWTACACS scheme
view.
hwtacacs scheme
hwtacacs-scheme-name
N/A
3. Specify HWTACACS
authentication servers.
• Specify the primary
HWTACACS authentication
server:
primary authentication
ip-address [ port-number | key
[ cipher | simple ] key |
vpn-instance
vpn-instance-name ] *
• Specify a secondary
HWTACACS authentication
server:
secondary authentication
ip-address [ port-number | key
[ cipher | simple ] key |
vpn-instance
vpn-instance-name ] *
Configure at least one
command.
No authentication server is
specified by default.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English