Huawei quidway s7700 - Configuring a Group VLAN for a Subordinate VLAN; Configuring a Separate VLAN for a Subordinate VLAN

The VLAN ID ranges from 1 to 4094. If VLANs need to be created in batches, run the vlan
batch { vlan-id1 [ to vlan-id2 ] } &<1-10> command to create VLANs in batches, and then run
the vlan vlan-id command to enter the view of a specified VLAN.
Step 3 Run:
mux-vlan
The VLAN is configured as a principal VLAN.
The VLAN ID assigned to a principal VLAN can no longer be used to configure any VLANIF
interface, super-VLAN, or sub-VLAN.
----End
3.7.3 Configuring a Group VLAN for a Subordinate VLAN
A VLAN associated with a group port is called a group VLAN. Group ports in a group VLAN
can communicate with each other.
Context
In a MUX VLAN, group VLANs cannot share the same VLAN ID with a separate VLAN.
Do as follows on a switching device that requires a group VLAN:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The view of a created principal VLAN is displayed.
Step 3 Run:
subordinate group vlan-id1 [ to vlan-id2 ]
A group VLAN is configured for the subordinate VLAN.
In this command, vlan-id1 and vlan-id2 specify a range of VLAN IDs. The value is an integer
ranging from 1 to 4094. The value of vlan-id2 must be greater than the value of vlan-id1.
The VLAN ID assigned to a group VLAN can be assigned to no other VLANIF interface, super-
VLAN, or sub-VLAN.
----End
3.7.4 Configuring a Separate VLAN for a Subordinate VLAN
A VLAN associated with separate ports is called a separate VLAN. Ports in a separate VLAN
cannot communicate with each other.
Context
Group VLANs and separate VLANs in one MUX VLAN cannot use the same VLAN ID.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
103