Huawei quidway s7700 - Configuring GVRP; Establishing the Configuration Task; Enabling GVRP

6.3 Configuring GVRP
This section describes how to configure the GVRP function.
6.3.1 Establishing the Configuration Task
Applicable Environment
On a complicated Layer 2 network, you can enable interfaces to dynamically join or leave
VLANs by configuring the GVRP function. This simplifies the configuration
Pre-configuration Tasks
Before configuring the GVRP function, complete the following task:
l Adding the GVRP interfaces to all VLANs
Data Preparation
To configure the GVRP function, you need the following data.
No.
Data
1 (Optional) Registration mode of GVRP interfaces
2 (Optional) Values of GARP timers
6.3.2 Enabling GVRP
Context
Do as follows on the S7700 to enable GVRP.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
gvrp
GVRP is enabled globally.
Step 3 Run:
interface interface-type interface-number
The interface view is displayed.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 6 GVRP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
334