Huawei quidway s7700 - Example for Connecting a Sub-Interface Enabled with Double-Tag VLAN Mapping to a VLL Network

mpls l2vpn
mpls l2vpn default martini
#
mpls ldp
#
mpls ldp remote-peer 1.1.1.9
remote-ip 1.1.1.9
#
interface Vlanif 30
ip address 10.2.2.1 255.255.255.0
mpls
mpls ldp
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 30
port hybrid tagged vlan 30
#
interface GigabitEthernet2/0/0
#
interface GigabitEthernet2/0/0.1
control-vid 2000 dot1q-termination
dot1q termination vid 20
mpls l2vc 1.1.1.9 101
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 10.2.2.0 0.0.0.255
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 20
#
interface Vlanif 20
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 20
#
return
5.12.9 Example for Connecting a Sub-interface Enabled with
Double-Tag VLAN Mapping to a VLL Network
Networking Requirements
As shown in Figure 5-9, CE1 and CE2 are connected to PE1 and PE2 respectively through
VLANs.
A Martini VLL is set up between CE1 and CE2.
Switch1 is connected to CE1 and PE1.
Switch2 is connected to CE2 and PE2.
Selective QinQ is configured on the interfaces connected to CEs so that the switches add the
VLAN tags specified by the carrier to the packets sent from CEs.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
251