Procedure
l Run the display voice-vlan [ vlan-id ] status command to check information about the
voice VLAN, including the working mode, security mode, aging timer value and the 802.1p
priority and DSCP value as well as the configuration of the port enabled with the voice
VLAN function.
l Run the display voice-vlan oui command to check information about the OUI of the voice
VLAN, including the mask and description of the OUI.
----End
3.9 Configuring an mVLAN to Implement Integrated
Management
Configuring an mVLAN allows users to use the IP address of the VLANIF interface
corresponding to the mVLAN to log in to a management switch to manage devices attached to
the switch.
3.9.1 Establishing the Configuration Task
Before configuring an mVLAN to implement integrated management, familiarize yourself with
the applicable environment, complete the pre-configuration tasks, and obtain the data required
for the configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
An mVLAN can be configured to help a user use an NMS to manage indirectly-connected
devices.
After an mVLAN is configured, a user can use the IP address of the VLANIF interface
corresponding to the mVLAN to telnet to a management switch and manage devices attached
to the switch.
Pre-configuration Tasks
Before configuring an mVLAN, complete the following task:
l Creating a VLAN
Data Preparation
To configure an mVLAN, you need the following data.
No.
Data
1 VLAN ID
3.9.2 Configuring an mVLAN
An mVLAN allows a user to use the IP address of the VLANIF interface corresponding to the
mVLAN to telnet to a management switch to manage devices attached to the switch.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
113
To Next Page
Loading...
Need help?
General
