Huawei quidway s7700 - Checking the Configuration; Configuration Examples; Example for Configuring Mapping of Single VLAN Tag

Step 6 Run:
port hybrid tagged vlan vlan-id
The interface is added to the VLAN specified by vlan-id.
Step 7 Run:
trust upstream ds-domain-name
The interface is bound to the DiffServ domain and the mapping in the DiffServ domain is applied
to the interface.
By default, the priority is not changed when the internal priority is mapped to the external
priority.
----End
4.6.4 Checking the Configuration
Procedure
l Run the display this command in the view of the incoming interface to check the
configuration of VLAN mapping based on the VLAN priority.
l Run the display this command in the view of the outgoing interface to check the
configuration of VLAN mapping based on the VLAN priority.
----End
4.7 Configuration Examples
This section provides several examples of VLAN mapping configuration.
4.7.1 Example for Configuring Mapping of Single VLAN Tag
Networking Requirements
As shown in Figure 4-1, users in VLAN 6 need to communicate with users in VLAN 5 through
VLAN 10 on the network.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 4 VLAN Mapping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
174