Huawei quidway s7700 - Configuring the Eth-Trunk to Work in Static LACP Mode; Adding Member Interfaces to an Eth-Trunk

No. Data
1 Number of the Eth-Trunk
2 Type and number of the member interface
3 Maximum number of active interfaces
2.4.2 Configuring the Eth-Trunk to Work in Static LACP Mode
Context
NOTE
Check whether the Eth-Trunk contains member interfaces before you configure the operation mode of the
Eth-Trunk. If the Eth-Trunk contains member interfaces, the operation mode of the Eth-Trunk cannot be
changed. To delete member interfaces from the Eth-Trunk, run the undo eth-trunk trunk-id command in
the interface view or run the undo trunkport interface-type interface-number command in the Eth-Trunk
view.
Do as follows on the S7700 where you need to configure an Eth-Trunk of static LACP mode.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk view is displayed.
Step 3 Run:
mode lacp-static
The Eth-Trunk is configured to work in static LACP mode.
By default, an Eth-Trunk works in manual load balancing mode.
If the local device is configured with an Eth-Trunk of static LACP mode, you must configure
the Eth-Trunk of static LACP mode on the peer device.
----End
2.4.3 Adding Member Interfaces to an Eth-Trunk
Context
Do as follows on the S7700 where you need to configure member interfaces of an Eth-Trunk.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 2 Link Aggregation Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
27