Huawei quidway s7700 - Configuring VLAN Mapping of Double Tags on a Sub-Interface; Configuring VLAN Stacking on a Sub-Interface; Configuring VPLS

5.10.5 Configuring VLAN Mapping of Double Tags on a Sub-
interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:
qinq mapping pe-vid vlan-id1 ce-vid vlan-id2 [ to vlan-id3 ] map-vlan vid vlan-id4
VLAN mapping of double tags is configured on the sub-interface.
----End
5.10.6 Configuring VLAN Stacking on a Sub-interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:
qinq stacking vid vlan-id1 [ to vlan-id2 ] pe-vid vlan-id3
VLAN stacking is configured on the sub-interface.
----End
5.10.7 Configuring VPLS
You need to configure the VPLS function on the CE, PE, and P. For details, see "VPLS
Configuration" in the Quidway S7700 Smart Routing Switch Configuration Guide - VPN. When
configuring VPLS, you can adopt Martini VPLS or Kompella VPLS.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
211