Huawei quidway s7700 - Checking Configuration; Configuring VLAN-Based Layer 2 Protocol Transparent Transmission

The default VLAN of the interface is configured.
Step 4 Run:
port hybrid untagged vlan vlan-id
The interface is added to the default VLAN in untagged mode.
Step 5 Run:
port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
The interface is added to the specified VLANs in tagged mode.
NOTE
The range of VLAN IDs specified in this step must include VLAN IDs of Layer 2 protocol packets from
user networks.
Step 6 Run:
l2protocol-tunnel { all | protocol-type | user-defined-protocol protocol-name }
enable
Layer 2 protocol transparent transmission is enabled on the interface.
NOTE
l For details on how to add an interface to VLANs, see the VLAN configuration in the S7700
Configuration Guide- Ethernet.
l Before specifying a user-defined protocol in the l2protocol-tunnel command, run the l2protocol-
tunnel user-defined-protocol command to define characteristic information about the Layer 2
protocol. STP packets have a default MAC address for replacing the original destination MAC address.
For packets of other Layer 2 protocols, you need to configure a global MAC address to replace the
destination MAC address. For details, see l2protocol-tunnel group-mac.
l The l2protocol-tunnel and l2protocol-tunnel vlan commands cannot specify the same protocol type
on the same interface; otherwise, the configurations conflict.
----End
11.3.5 Checking Configuration
Context
Configurations of interface-based Layer 2 protocol transparent transmission are complete.
Procedure
l Run the display l2protocol-tunnel group-mac { all | protocol-type | user-defined-
protocol protocol-name } command to check information about transparent transmission
of specified or all Layer 2 protocol packets.
----End
11.4 Configuring VLAN-based Layer 2 Protocol Transparent
Transmission
When each interface of devices on the backbone network is connected to multiple user networks
and Layer 2 protocol packets sent from user network contain VLAN tags, you can configure
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 11 Layer 2 Protocol Transparent Transmission Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
581