Huawei quidway s7700 - Configuring a Qinq Sub-Interface; Configuring VLAN Mapping of a Single Tag on a Sub-Interface

The control VLAN ID and encapsulation mode of the sub-interface are set.
Step 4 Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ]
The VLANs whose packets are allowed to pass through the dot1q sub-interface are specified.
----End
5.10.3 Configuring a QinQ Sub-interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:control-vid vid qinq-terminationThe control VLAN ID and encapsulation mode of the
sub-interface are set.
Step 4 Run:
qinq termination pe-vid pe-vid ce-vid ce-vid1 [ to ce-vid2 ]
The VLANs whose packets are allowed to pass through the QinQ sub-interface are specified.
----End
5.10.4 Configuring VLAN Mapping of a Single Tag on a Sub-
interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:
qinq mapping vid vlan-id1 [ to vlan-id2 ] map-vlan vid vlan-id3
VLAN mapping of a single tag is configured on the sub-interface.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
210