EasyManua.ls Logo

Huawei quidway s7700 - Enabling Qinq-Based Layer 2 Transparent Transmission on an Interface; Checking the Configuration

Huawei quidway s7700
648 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11.5.4 Enabling QinQ-based Layer 2 Transparent Transmission on
an Interface
Context
Do as follows on PEs according to the type of Layer 2 protocol packets to be transparently
transmitted.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The user-side interface view is displayed.
Step 3 Run:
port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
The interface is added to the specified VLANs in untagged mode.
Step 4 Run:
port vlan-stacking vlan vlan-id1 [ to vlan-id2 ] stack-vlan vlan-id3
The interface is configured to add an outer VLAN tag to the Layer 2 protocol packets.
Step 5 Run:
l2protocol-tunnel { all | protocol-type | user-defined-protocol protocol-name }
{ vlan low-id [ to high-id ] } &<1-10>
VLAN-based Layer 2 protocol transparent transmission is enabled on the interface.
NOTE
l The outer VLAN tag (vlan-id3) specified in step 5 must be included in the VLAN range specified in
step 6.
l For details on how to add an interface to VLANs in untagged mode, see the VLAN configuration in
the S7700 Configuration Guide- Ethernet.
l Before specifying a user-defined protocol in the l2protocol-tunnel vlan command, run the l2protocol-
tunnel user-defined-protocol command to define characteristic information about the Layer 2
protocol. STP packets have a default MAC address for replacing the original destination MAC address.
For packets of other Layer 2 protocols, you need to configure a global MAC address to replace the
destination MAC address. For details, see l2protocol-tunnel group-mac.
l The l2protocol-tunnel vlan and l2protocol-tunnel commands cannot specify the same protocol type
on the same interface; otherwise, the configurations conflict.
----End
11.5.5 Checking the Configuration
Context
Configurations of Layer 2 protocol transparent transmission are complete.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 11 Layer 2 Protocol Transparent Transmission Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
588

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals