Huawei quidway s7700 - Checking the Configuration; Configuring VLAN Stacking Based on the VLAN Priority; Establishing the Configuration Task

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
traffic-policy policy-name inbound
The traffic policy is applied in the inbound direction of the interface.
----End
5.5.7 Checking the Configuration
Procedure
Step 1 Run the display current-configuration command to check the configuration of flow-based
selective QinQ.
----End
5.6 Configuring VLAN Stacking Based On the VLAN
Priority
This section describes how to configure VLAN stacking based on the VLAN priority.
5.6.1 Establishing the Configuration Task
Applicable Environment
By configuring VLAN stacking based on the VLAN priority, the outer VLAN tag and the priority
in the outer VLAN tag are added to the packets passing through the S7700.
Pre-configuration Tasks
Before configuring VLAN stacking based on the VLAN priority, complete the following task.
l Configuring the VLAN
Data Preparation
To configure VLAN stacking based on the VLAN priority, you need the following data.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
198