Step 2 Run:
load-balance-profile profile-name
A profile of enhanced Eth-Trunks in load balancing mode is created and the profile view is
displayed.
Step 3 Run:
l2 field [ dmac | l2-protocol | smac | sport | vlan ]
*
The load balancing mode of Layer 2 packets is specified in the profile.
By default, load balancing of Layer 2 packets is based on the source MAC address (smac),
destination MAC address (dmac), and VLAN (vlan) of each packet.
Step 4 Run:
ipv4 field [ dip | l4-dport | l4-sport | protocol | sip | sport | vlan ]
*
The load balancing mode of Layer 3 IPv4 packets is specified in the profile.
By default, load balancing of Layer 3 IPv4 packets is based on the source IP address (sip) and
destination IP address (dip) of each packet.
Step 5 Run:
ipv6 field [ dip | l4-dport | l4-sport | protocol | sip | sport | vlan ]
*
The load balancing mode of Layer 3 IPv6 packets is specified in the profile.
By default, load balancing of Layer 3 IPv6 packets is based on the source IP address (sip) and
destination IP address (dip) of each packet.
Step 6 Run:
mpls field [ 2nd-label | dip | sip | sport | top-label | vlan ]
*
The load balancing mode of MPLS packets is specified in the profile.
By default, load balancing of MPLS packets is based on the two outmost labels ( top-label and
2nd-label) of each packet.
----End
2.3.7 (Optional) Configuring the Load Balancing Mode for
Unknown Unicast Traffic
Context
Do as follows on the S7700 where you need to configure the load balancing mode for unknown
unicast traffic.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
unknown-unicast load-balance { dmac | smac | smacxordmac | enhanced }
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 2 Link Aggregation Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25
To Next Page
Loading...
