The view of the created MSTP process is displayed.
Step 3 Run:
stp tc-notify process 0
TC notification is enabled in the MSTP process.
After the stp tc-notify process 0 command is run, the current MSTP process notifies the MSTIs
in MSTP process 0 to update MAC entries and ARP entries after receiving a TC-BPDU. This
prevents services from being interrupted.
----End
9.3.7 Checking the Configuration
After MSTP multi-process is configured, check whether the configurations take effect.
Prerequisite
All configurations of MSTP multi-process are complete.
Procedure
Step 1 Run the display stp [ process process-id ] [ instance instance-id ] [ interface interface-type
interface-number | slot slot-id ] [ brief ] command to view spanning-tree status and statistics.
----End
9.4 Configuring MSTP Parameters on an Interface
MSTP implements RSTP rapid convergence. To achieve rapid convergence, you need to
configure proper MSTP parameters.
9.4.1 Establishing the Configuration Task
Before configuring basic MSTP parameters, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This will help
you complete the configuration task quickly and accurately.
Applicable Environment
In some specific networks, MSTP parameters will affect the speed of network convergence.
Configuring proper MSTP parameters is required.
NOTE
The default parameters also can be used to complete MSTP rapid convergence. Therefore, the configuration
procedures and steps in this command task are all optional.
Pre-configuration Tasks
Before configuring MSTP parameters, complete the following task:
l Configuring basic MSTP functions
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 9 MSTP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
443
To Next Page
Loading...
Need help?
General
