1 Ethernet Interface Configuration
About This Chapter
This chapter describes the basic knowledge, methods, and examples for configuring the Ethernet
interface.
1.1 Introduction to Ethernet Interfaces
This section describes the Ethernet interfaces.
1.2 Ethernet Interface Features Supported by the S7700
This section describes the Ethernet interface features supported by the S7700.
1.3 Configuring Basic Attributes of the Ethernet Interface
This section describes how to configure the description, cable type, duplex mode, rate, and auto-
negotiation an Ethernet interface, and switch between the optical and electrical interfaces and
between Layer 2 and Layer 3 interfaces.
1.4 Configuring Advanced Attributes of an Ethernet Interface
This section describes how to configure the loopback on the Ethernet Interface, minimum
interval for re-enabling an interface, port group, maximum frame size, flow control, flow control
auto-negotiation, cable test, sub-interface IP address, and port isolation.
1.5 Maintaining Ethernet Interfaces
This section describes how to maintain Ethernet interfaces.
1.6 Configuration Examples
This section provides several configuration examples of Ethernet interfaces.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 1 Ethernet Interface Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1
To Next Page
Loading...
