Step 4 Run:
speed { 10 | 100 | 1000 }
The rate is set for the interface.
By default, an Ethernet interface works at its maximum rate when auto-negotiation is disabled
on the interface.
----End
1.3.6 (Optional) Enabling Auto-Negotiation
Context
Do as follows on the S7700 where you want to enable auto-negotiation and on the switch
connected to this S7700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
negotiation auto
Auto-negotiation is enabled on the interface.
By default, an interface works in auto-negotiation mode.
The local interface and peer interface must work in the same mode, that is, both in auto-
negotiation mode or not.
NOTE
100M and 10G optical interfaces do not support auto negotiation.
----End
1.3.7 (Optional) Switching Between Optical and Electrical
Interfaces
Context
Do as follows on the S7700 where you need to switch between optical and electrical interfaces.
Procedure
Step 1 Run:
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 1 Ethernet Interface Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6
To Next Page
Loading...
Need help?
General
