Huawei quidway s7700 - Checking the Configuration; Setting the Protocol Type in the Outer VLAN Tag; Establishing the Configuration Task

system-view
The system view is displayed.
Step 2 Run:
diffserv domain ds-domain-name
A DiffServ domain is created and the DiffServ domain view is displayed.
Step 3 Run:
8021p-outbound service-class color map 8021p-value
The internal priority of outgoing packets in a VLAN is mapped to the 802.1p priority on the
interface of the DiffServ domain.
Step 4 Run:
quit
Exit from the DiffServ domain view.
Step 5 Run:
interface interface-type interface-number
The interface view is displayed.
Step 6 Run:
port hybrid tagged vlan vlan-id
The interface is added to the VLAN specified by vlan-id.
Step 7 Run:
trust upstream ds-domain-name
The interface is bound to the DiffServ domain and the mapping in the DiffServ domain is applied
to the interface.
By default, the priority is not changed when the internal priority is mapped to the external
priority.
----End
5.6.4 Checking the Configuration
Procedure
l Run the display this command in the view of the incoming interface to check the
configuration of VLAN stacking based on the VLAN priority.
l Run the display this command in the view of the outgoing interface to check the
configuration of VLAN stacking based on the VLAN priority.
----End
5.7 Setting the Protocol Type in the Outer VLAN Tag
This section describes how to set the protocol type in the outer VLAN tag on an interface.
5.7.1 Establishing the Configuration Task
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
200