NOTE
l HVRP can be enabled only on trunk interfaces.
l When you configure HVRP attributes, it is recommended that you delete the default VLAN (VLAN
1) from the interface.
l HVRP can be enabled on an interface only after HVRP is enabled globally.
l After HVRP is disabled globally, this function is disabled on all the interfaces.
----End
12.3.4 (Optional) Setting the VLAN Registration Timer
Context
Do as follows on the S7700 where the VLAN registration timer needs to be set.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
hvrp timer registervlan timer-interval
The VLAN registration timer is set.
By default, the value of the VLAN registration timer is 5 seconds.
NOTE
l The value of the VLAN registration timer must be smaller than the aging time of registered VLANs.
It is recommended that the aging time of registered VLANs be three times the value of the VLAN
registration timer or larger.
l In a ring topology, the same VLAN registration timer and the same aging time of registered VLANs
must be set for all the devices on the ring.
----End
12.3.5 (Optional) Setting the Aging Time of Registered VLANs
Context
Do as follows on the S7700 where the aging time of registered VLANs needs to be set.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
hvrp timer registervlan-age timer-interval
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 12 HVRP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
618
To Next Page
Loading...
Need help?
General
