Pre-configuration Tasks
Before configuring MSTP multi-process, complete the following task:
l Configuring basic MSTP functions
Data Preparation
To configure MSTP multi-process, you need the following data.
No. Data
1 IDs of MSTP processes
2 Priority of a switching device in an MSTI
9.3.2 Creating an MSTP Process
A process ID uniquely identifies an MSTP multi-process. After an MSTP device binds its ports
to different processes, the MSTP device performs the MSTP calculation based on processes, and
only relevant ports in each process take part in MSTP calculation.
Context
Do as follows on the devices connected to access rings:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stp process process-id
An MSTP process is created and the MSTP process view is displayed.
Step 3 Run:
stp mode mstp
A working mode is configured for the MSTP process.
The default mode is MSTP.
NOTE
l After a device starts, there is a default MSTP process with the ID 0. MSTP configurations in the system
view and interface view belong to this process. The default working mode of this process is MSTP.
l To add an interface to an MSTP process with the ID of non-zero, run the stp process command and
then the stp binding process command.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 9 MSTP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
440
To Next Page
Loading...
