The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
virtual-cable-test
A cable test is performed on the interface.
NOTE
l The test result is only for reference.
l Running the virtual-cable-test command may affect services on the interface in a short period of time.
l Before performing a cable test, shut down the remote interface or remove the network cable from the
remote interface. Otherwise, signals from the remote interface may make the test result inaccurate.
----End
1.4.10 (Optional) Assigning an IP Address to an Ethernet Sub-
interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
An Ethernet sub-interface is created and the Ethernet sub-interface view is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the Ethernet sub-interface is configured.
Only the E-series and F-series boards supports the configuration of sub-interfaces.
----End
1.4.11 Checking the Configuration
Procedure
l Run the display port-group [ all | port-group-name ] command to check information about
a port group.
l Run the display interface [ interface-type [ interface-number [.subnumber ] ] ] command
to check information about auto-negotiation capability on an Ethernet interface.
l Run the display virtual-cable-test interface-type interface-number command to check the
cable test result on an Ethernet interface.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 1 Ethernet Interface Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13
To Next Page
Loading...
Need help?
General
